Home / Queensland / Products / Home Theatre & Stereo Components / Home Theatre Amplifiers / McIntosh Multi Channel Amplifiers / McIntosh MC303 /

McIntosh MC303

mc303_angle_l.jpg

At 300 watts per channel the new McIntosh MC303 Three Channel Power Amplifier with Autoformers delivers its maximum rated output power into 2, 4, or 8 ohm loads for the lowest noise and distortion performance possible. Premium cosmetics featuring a ½” thick glass faceplate, custom machined and anodized aluminum handles, and a mirror polished stainless steel chassis are standard equipment on the MC303. Power Guard, a McIntosh circuit innovation, maximizes sound quality at high power levels while our Sentry Monitor feature provides continuous short circuit protection of the amplifier and connected loudspeakers. A triple bank of Peak Reading Watt Meters provides instant recognition of power output and may be switched off for theater use.$14,990 rrp

MC303 Three Channel Power Amplifier

Power Output
Minimum sine wave continuous average power output per channel, all channels operating: 300 watts into a 2 ohm, 4 ohm or 8 ohm load

Output Load Impedance: 2, 4 or 8 ohms

Rated Power Band:20Hz to 20,000Hz

Total Harmonic Distortion
0.005% maximum harmonic distortion at any power level from 250 milliwatts to rated power, 20Hz to 20,000Hz

Dynamic Headroom: 1.8dB

Frequency Response:
+0, -0.25dB from 20Hz to 20,000Hz
+0, -3dB from 10Hz to 100,000Hz

Input Sensitivity (for rated output):
1.7 Volt Unbalanced
3.4 Volt Balanced

Signal To Noise Ratio (A-Weighted): 112dB below rated output

Intermodulation Distortion:
0.005% maximum, if the instantaneous peak power output does not exceed twice the rated power output for any combination of frequencies from 20Hz to 20,000Hz.

Wide Band Damping Factor: Greater than 40

Input Impedance: 10,000 ohms

Power Guard: Less than 2% THD with up to 14dB overdrive at 1,000Hz

Power Control Input: 5VDC - 12VDC

Power Control Output: 12VDC, 25mA maximum, delay 0.2 seconds

Power Requirements:
100 Volts, 50/60Hz at 12 Amps
110 Volts, 50/60Hz at 11 Amps
120 Volts, 50/60Hz at 10 Amps
220 Volts, 50/60Hz at 6 Amps
230 Volts, 50/60Hz at 6 Amps
240 Volts, 50/60Hz at 6 Amps
Standby: Less than 1 watt

Note: Refer to the rear panel of the MC303 for the correct voltage.

Overall Dimensions:
Width is 17-3/4 inches (45.09cm)
Height is 12-3/8 inches (31.43cm) including feet
Depth is 22 inches (55.88cm) including the Front Panel and
Cables

Weight:
155 pounds (70.3 kg) net, 180 pounds (81.6 kg) in shipping carton

Shipping Carton Dimensions
Width is 31 inches (78.74cm)
Depth is 28 inches (71.12cm)
Height is 17-1/4 inches (43.82cm)

CEDIA Member and Sound Image Awards Winner